Sunday, August 24, 2014

Mid-Century Modern Chair Makeover Part 3

It's now come to the big day on my chair makeover project. Upholstery. It's a big day and long one. There are plenty of blog, books, and how to articles out there for upholstery. I'm only going to give you an overview of what I did along with a few tips. My mom helped me with this part as she has upholstery experience.


This first task was to redo the seat of this chair as it was lacking it's original support. I used jute webbing. There is a tool specifically for helping to pull the jute taunt. I didn't want to spend the money on one so I used a scrap 2 by 4 and applied the same principle at the special tool. You will use a lot of upholstery tacks so make sure you buy more than what you think you will need.



I covered the jute with 1 inch of foam and a thick polyester batting. The foam was cut cover the seat only. the batting is bigger and will wrap around the frame.


This chair has a loose cushion. I used 3 inch foam wrapped in batting. I used perle cotton thread to whip stitch the seams of the batting.


Okay here is something major important. You do not want the cover for your upholstery to be loose. I see this on design shows all the time. You want it to fit very, very snug. I marked my fabric with the shape of my foam. I then added a 1/2 inch to 5/8 inch seam allowance. That's it. Over time the foam and batting with compress and a wrinkled cushion is unattractive.


This is snug as you see here it doesn't seem like my side will fit but trust me it will look great.


I wrapped my cushion with a plastic garbage bag. This make it easier to put it in the snug fitting cover. I removed the plastic bag before stitching the seam closed.


The upholstery on the chair itself was pulled tight. You work opposite sides. Front the back, left then right. Depending on the shape of the item you may have to work in pleats in strategic places. Cut away excess fabric in small amounts. you can't place it back but you can remove more if you need to.
The green fabric was faded and not fit for another project so i used it for my dust cover.

My tips:
  1. coffee, soda, and snacks
  2. find someone to help you. Hopefully someone who has done upholstery or sewing work before. It's great if you can have an extra set of hands to help hold the fabric.
  3. read books or blogs to know the basic process of what you need to do
  4. patience
  5. tacks, lots and lots of upholstery tacks
  6. a day when you feel confident and not overly stressed. You might have some frustrations along the way. 

Finally for the part you have been waiting for the final results.



Part 1: The chair before and prep
Part 1.5: paint and upholstery selections
Part 2: painting

1 comment:

  1. so cute, that looks great!

    i use an air compressor powered staple gun instead of tacks.
    much faster, just as secure.

    ReplyDelete